CLI Reference Guide 4. System Commands
Version 6.4 41 January 2012
4 System Commands
The following describes the System configuration commands. To access these commands,
enter "configure system" at the Enabled mode prompt.
4.1 NTP
This command configures the Network Time Protocol (NTP) of the system.
Syntax:
The syntax of this command includes the following variations:
set primary-server <IP address>
set secondary-server <IP address>
set update-interval <seconds>
set utc-offset <utc-offset>
The command syntax format is described below:
Arguments Description
utc-offset
To Next Page
Loading...
