AudioCodes Mediant 800 MSBG - 5 Voip Commands; Interface; E1;T1, Bri

CLI Reference Guide 5. VoIP Commands
Version 6.4 57 January 2012
5 VoIP Commands
5.1 interface
5.1.1 E1/T1, bri
This command enters a specific PSTN interface (E1/T1 or BRI) configuration.
Syntax:
The syntax of this command includes the following variations:
interface bri <slot/port>
interface e1-t1 <slot/port>
set <parameter> <value>
Arguments Description
<parameter> <value> Sets the following table parameters:
 b-ch-negotiation
 call-re-rte-mode
 defaults
 isdn-bits-cc-behavior
 isdn-bits-incoming-calls-behavior
 isdn-bits-ns-behavior
 isdn-bits-ns-extension-behavior
 isdn-bits-outgoing-calls-behavior
 isdn-layer2-mode
 isdn-termination-side
 isdn-xfer-cab
 local-isdn-rbt-src
 oos-behavior
 ovrlp-rcving-type
 pi-in-rx-disc-msg
 pi-to-isdn
 play-rbt-to-trk
 protocol
 pstn-alrt-timeout
 rmv-calling-name
 trk-xfer-mode-type
For a description of these parameters, refer to the User's Manual.
Command Modes
Enable