AudioCodes Mediant 800 MSBG - Numbermapip2 Tel

CLI Reference Guide 5. VoIP Commands
Version 6.4 125 January 2012
5.16.8.3 NumberMapIp2Tel
This command defines the NumberMapIp2Tel settings.
Syntax:
gw manipulations NumberMapIp2Tel <index>
set <parameter> <value>
The command’s syntax format is described below:
Arguments Description
<index> Defines the table row index.
<parameter> <value> Sets the following table parameters:
 DestinationPrefix
 LeaveFromRight
 NumberPlan
 NumberType
 Prefix2Add
 RemoveFromLeft
 RemoveFromRight
 SourceAddress
 SourcePrefix
 Suffix2Add
 defaults
For a description of these parameters, refer to the User's Manual.
Defaults
NA
Command Modes
Enable
Examples:
The following example enables the source IP address.
(config-voip)# gw manipulations NumberMapIp2Tel 2
(NumberMapIp2Tel-2)# set sourceaddress 12.10.4.120