AudioCodes Mediant 800 MSBG - Configuring In-Band Signaling Settings; Media In-Band-Signaling

CLI Reference Guide 5. VoIP Commands
Version 6.4 147 January 2012
5.26 Configuring In-band Signaling Settings
The following defines how to configure In-band Signaling settings.
5.26.1 media in-band-signaling
This command configures the media in-band-signaling table.
Syntax:
The syntax of this command includes the following variations:
media in-band-signaling
set <parameter> <value>
The command syntax format is described below:
Arguments Description
<parameter> <value> Sets the following table parameters:
 COT-detector-enable
 CPT-detector-frequency-deviation
 DTMF-detector-enable
 DTMF-generation-twist
 DTMF-transport-type
 DTMF-volume
 IBS-detection-redirection
 MF-transport-type
 MFR1-detector-enable
 MFR2-backward-detector-enable
 MFR2-forward-detector-enable
 NTT-DID-signaling-form
 SIT-detector-enable
 UDT-detector-frequency-deviation
 call-progress-detector-enable
 caller-ID-transport-type
 caller-ID-type
 defaults
 digit-hangover-time-rx
 digit-hangover-time-tx
 telephony-events-max-duration
 user-defined-tones-detector-enable
For a description of these parameters, refer to the User's Manual.
Command Modes
Enable