AudioCodes Mediant 800 MSBG - Configuring RTP;RTCP Settings; Media RTP-RTCP

CLI Reference Guide 140 Document #: LTRT-17940
System and VoIP Functionalities
5.19 Configuring RTP/RTCP Settings
The following defines how to configure RTP/RTCP settings.
5.19.1 media RTP-RTCP
This command configures the RTP RTCP configuration.
Syntax:
media RTP-RTCP
set <parameter> <value>
The command’s syntax format is described below:
Arguments Description
<parameter> <value> Sets the following table parameters:
 CAS-transport-type
 RTP-redundancy-depth
 broken-connection-event-activation-mode
 broken-connection-event-timeout
 connection-establishment-notification-mode
 defaults
 disable-NAT-traversal
 disable-RTCP-randomization
 no-operation-enable
 no-operation-interval
 number-of-SID-coefficients
For a description of these parameters, refer to the User's Manual.
Defaults
NA
Command Modes
Enable
Examples:
The following example sets the ABCD signaling transport type over IP.
(config-voip)# media RTP-RTCP
(media-RTP-RTCP)# set CAS-transport-type events-only