CLI Reference Guide 3. General Commands
Version 6.4 37 January 2012
3.14 telnet
This command invokes a Telnet session towards a remote host.
Syntax:
The syntax of this command can include the following variations:
telnet <remote-host> <remote-port>
The command’s syntax format is described below:
Arguments Description
< remote-host > Defines the remote host IP address.
< remote-port > Defines the remote host port number. This argument is not
mandatory.
Defaults:
Default remote port is 23 (if not entered otherwise by the user).
Notes:
1. The telnet command is used mainly for remote management proposes.
2. A remote administrator can access the MSBG device’ CLI from the WAN leg while
performing the full authentication process.
3. The user can then invoke Telnet sessions towards other devices in the LAN in order to
manage them. That way, no special pin-holes or forwarding rules should be declared in
order to manage the LAN devices.
Command Modes:
Enable
Related Commands:
NA
Examples:
The following example invokes a Telnet session.
# telnet 10.4.4.25
To Next Page
Loading...
