AudioCodes Mediant 800 MSBG - Coders-And-Profiles Tel-Profile

CLI Reference Guide 80 Document #: LTRT-17940
System and VoIP Functionalities
5.8 coders-and-profiles tel-profile
This command defines the Tel Profile table.
Syntax:
coders-and-profiles tel-profile <index>
set <parameter> <value>
Arguments Description
<parameter> <value> Sets the following table parameters:
 CodersGroupID
 DtmfVolume
 EnableCurrentDisconnect
 EnableDigitDelivery
 EnableEC
 EnableEarlyMedia
 EnableReversePolarity
 FlashHookPeriod
 IPDiffServ
 InputGain
 IsFaxUsed
 JitterBufMinDelay
 JitterBufOptFactor
 MWIAnalog
 MWIDisplay
 ProfileName
 ProgressIndicator2IP
 SigIPDiffServ
 TelPreference
 TimeForReorderTone
 VoiceVolume
 defaults
 dial-plan-index
 digital-cut-through
 disconnect-on-busy-tone
 ec-nlp-mode
 enable-911-psap
 enable-agc
 enable-did-wink
 enable-fxo-double-answer
 enable-voice-mail-delay
 is-two-stage-dial
 swap-teltoip-phone-numbers
For a description of these parameters, refer to the User's Manual.