AudioCodes Mediant 800 MSBG - Digitalgw; Digital-Gw-Parameters

CLI Reference Guide 116 Document #: LTRT-17940
System and VoIP Functionalities
5.16.3 digitalgw
The following defines digitalgq commands.
5.16.3.1 digital-gw-parameters
This command defines the digital gateway parameters.
Syntax:
gw digitalgw digital-gw-parameters
set <parameter> <value>
The command’s syntax format is described below:
Arguments Description
<parameter> <value> Sets the following table parameters:
 PSTNReserved3
 add-ie-in-setup
 add-pref-to-redir-nb
 b-ch-negotiation
 cp-dst-nb-2-redir-nb
 defaults
 dflt-call-prio
 dflt-cse-map-isdn2sip
 dig-oos-behavior
 disc-on-bsy-tone-c
 disc-on-bsy-tone-i
 dscp-4-mlpp-flsh
 dscp-4-mlpp-flsh-ov
 dscp-4-mlpp-flsh-ov-ov
 dscp-4-mlpp-immed
 dscp-4-mlpp-prio
 dscp-4-mlpp-rtn
 epn-as-cpn-ip2tel
 epn-as-cpn-tel2ip
 ignore-bri-los-alarm
 isdn-facility-trace
 isdn-tnl-ip2tel
 isdn-tnl-tel2ip
 isdn-trsfr-on-conn
 mfcr2-category
 mlpp-dflt-namespace
 mlpp-dflt-srv-domain
 mlpp-norm-ser-dmn
 ni2-cpc
 np-n-ton-2-redirnb
 play-l-rbt-isdn-trsfr
 preemp-tone-dur
 qsig-tunneling