CLI Reference Guide 3. General Commands
Version 6.4 39 January 2012
3.16 write
This command writes the current configuration set and auxiliary files to the NV memory.
Syntax:
The syntax of this command can include the following variations:
write
Defaults:
NA
Notes:
This command should be invoked in the following scenarios in order to save the
configuration set and auxiliary files to the NV memory:
• After completing a configuration set (i.e. after invoking one or more of the
commands in the ‘config’ mode command-set)
• After copying a new auxiliary file (‘copy’ command)
• After copying a new configuration file (‘copy’ command)
• After erasing an auxiliary file (‘erase’ command)
Command Modes:
Enable
Related Commands:
reload, copy, erase, write factory
Examples:
The following example writes configuration and auxiliary files to NV memory.
# write
To Next Page
Loading...
