CLI Reference Guide 34 Document #: LTRT-17940
System and VoIP Functionalities
3.11 enable password
This command sets the Enable Mode password for switching to Enable Mode from Basic
mode.
Syntax:
The syntax of this command can include the following variations:
enable password <password>
The command’s syntax format is described below:
Arguments Description
<password> Enter the new password.
Defaults:
NA
Notes:
NA
Command Modes:
Enable
Related Commands:
disable, enable
Examples:
The following example command sets the Enable Mode password. To ‘Admin’
# enable password Admin
To Next Page
Loading...
