AudioCodes Mediant 800 MSBG - Fxo-Setting

CLI Reference Guide 5. VoIP Commands
Version 6.4 113 January 2012
5.16.2.2 fxo-setting
This command defines the fxo settings.
Syntax:
# gw analoggw fxo-setting
# set <parameter> <value>
The command’s syntax format is described below:
Arguments Description
<parameter> <value> Sets the following table parameters:
 answer-supervision
 defaults
 dialing-mode
 disc-on-bsy-tone-c
 disc-on-dial-tone
 fxo-autodial-play-bsytn
 fxo-dbl-ans
 guard-time-btwn-calls
 reorder-tone-duration
 ring-detection-tout
 rings-b4-det-callerid
 snd-mtr-msg-2ip
 time-wait-b4-dialing
 waiting-4-dial-
tone
For a description of these parameters, refer to the User's Manual.
Defaults
NA
Command Modes
Enable
Examples:
The following example enables the wait for dial tone before initiating an outgoing call to the
PBX/PSTN (FXO one-stage dialing mode).
(config-voip)# gw analoggw fxo-setting
(gw-analogGW-fxo)# set waiting-4-dial-tone enable