CLI Reference Guide 16 Document #: LTRT-17940
System and VoIP Functionalities
2.2.3 Using CLI Shortcuts
The MSBG CLI provides several shortcuts to help you configure your MSBG product more
easily. See the following table for descriptions.
Table 2-1: CLI Shortcuts
Shortcut Description
Up arrow key To re-display a previously entered command, use the Up arrow key.
Continuing to press the Up arrow key cycles through all commands
entered, starting with the most recent command.
<Tab> key Pressing the <Tab> key after entering a partial (but unique) command
completes the command, displays it on the command prompt line, and
waits for further input.
Pressing the <Tab> key after entering a partial and not unique command
displays all completing options.
?
The MSBG CLI contains help to guide you through the configuration
process. Using the question mark, do one of the following:
Displays a list of all subcommands in the current mode. For example:
(config)# interface ?
BVI bridge interface
GigabitEthernet GigabitEthernet
vlan Vlan interface
Displays a list of available commands beginning with certain letter(s). For
example:
(config)# interface G?
GigabitEthernet GigabitEthernet
Obtains syntax help for a specific command by entering the command, a
space, and then a question mark (?). The MSBG CLI displays the range of
values and a brief description of the next parameter expected for that
particular command. For example:
(config)# interface vlan ?
[1-3999] Vlan ID
In case there is a command that can be invoked (all its arguments are
inserted), using the question mark at its end displays <cr>. For example:
(config)# logging host 10.1.1.1 ?
<cr>
<Ctrl + A>
Jump to the beginning of the displayed command line. This shortcut is
To Next Page
Loading...
