AudioCodes Mediant 800 MSBG - Dtmf-And-Suppl Dtmf-And-Dialing

CLI Reference Guide 118 Document #: LTRT-17940
System and VoIP Functionalities
5.16.4 dtmf-and-suppl dtmf-and-dialing
This command defines the dtmf and supplementary parameters.
Syntax:
gw dtmf-and-suppl dtmf-and-dialing
set <parameter> <value>
The command’s syntax format is described below:
Arguments Description
<parameter> <value> Sets the following table parameters:
 defaults
 dflt-dest-nb
 dial-plan-index
 digitmapping
 dt-duration
 hook-flash-option
 hotline-dt-dur
 isdn-tx-overlap
 min-dg-b4-routing
 mxdig-b4-dialing
 rfc-2833-in-sdp
 special-digit-rep
 special-digits
 telephony-events-payload-type-tx
 time-btwn-dial-digs
For a description of these parameters, refer to the User's Manual.
Defaults
NA
Command Modes
Enable
Examples:
The following example enables ISDN Overlap IP to Tel Dialing.
(config-voip)# gw dtmf-and-suppl dtmf-and-dialing
(gw-dtmf-and-dial)# set isdn-tx-overlap on