AudioCodes Mediant 800 MSBG - Fxs-Fxo

CLI Reference Guide 5. VoIP Commands
Version 6.4 59 January 2012
5.1.2 fxs-fxo
This command enters a specific analog interface (FXS or FXO) configuration.
Syntax:
The syntax of this command includes the following variations:
interface fxs-fxo <slot/port>
set <parameter> <value>
The command syntax format is described below:
Arguments Description
<parameter> <value> Sets the following table parameters:
 bellcore-callerid-type-one-sub-standard
 bellcore-vmwi-type-one-standard
 caller-ID-type
 caller-id-timing-mode
 current-disconnect-duration
 default-linepolarity-state
 defaults
 disable-analog-auto-calibration
 enable-analog-dc-remover
 enable-fxo-current-limit
 etsi-callerid-type-one-sub-standard
 etsi-vmwi-type-one-standard
 far-end-disconnect-type
 flash-hook-period
 fxo-country-coefficients
 fxo-dc-termination
 fxs-country-coefficients
 fxs-rx-gain-control
 fxs-tx-gain-control
 metering-on-time
 metering-type
 min-flash-hook-time
 mwi-indication-type
 polarity-reversal-type
 rx-gain-control
 time-to-sample-analog-line-voltage
 trk-xfer-mode-type
For a description of these parameters, refer to the User's Manual.
Command Modes
Enable