CLI Reference Guide 60 Document #: LTRT-17940
System and VoIP Functionalities
Related Commands:
show voip interface fxs-fxo
The above commands give the user the interface status, main PM parameters and main
configuration parameters.
Examples:
This example sets the metering method for charging pulses.
(config-system)# interface fxs-fxo
(fxs-fxo)# set metering-type 12-kHz-sinusoidal-bursts
The following example enters a specific analog interface configuration.
# show voip interface fxs-fxo
Module in slot 1, Ports type is FXS
Port 1 status:
Chip Revision: 2
Hook state(1- off hook, 0- onhook): 0
Message Waiting Indication: 0
Ring:0
Reversal Polarity:0
Tx Gain Control: 0db
Rx Gain Control: 0db
Port configuration:
Various timing parameters:
WinkTime 200 ms
CurrentDisconnectDuration 900 ms
FlashHookPeriod 700 ms
MinFlashHookTime 300 ms
Caller ID and MWI parameters:
Primary Caller ID and MWI type is 0
AnalogCallerIDTimingMode is CallerID transferred between
first and second rings
BellcoreCallerIDTypeOneSubStandard is 0
ETSICallerIDTypeOneSubStandard is 0
ETSIVMWITypeOneStandard is 0
BellcoreVMWITypeOneStandard is 0
Various signal indications parameters:
PolarityReversalType is 0
MeteringType is 0
LifeLineType is acLifeLineType_Hardware_Only
Country Coefficients is set to USA
To Next Page
Loading...
