BinTec RS353a - Configuration Access; Access Profiles

Fields in the Global RADIUS Options menu.
Field Description
Authentication for PPP
Dialin
By default, the following authentication sequence is used for in-
coming calls with RADIUS: First CLID, then PPP and then PPP
with RADIUS.
Options:
• ": Only inband RADIUS requests (PAP,CHAP, MS-
CHAP V1 & V2) (i.e. PPP requests without CLID) are sent to
the RADIUS server defined in Server IP Address.
• -" 605! : Only outband RADIUS requests (i.e. re-
quests for calling line identification = CLID) are sent to the
RADIUS server.
" is enabled by default, -" 605! is diabled
by default.
5.6 Configuration Access
In the Configuration Access menu you can configure user profiles.
To do so, you create access profiles and users and assign each user at least one access
profile. An access profile makes available that part of the GUI that a user requires for their
tasks. Parts of the GUI that are not required are blocked.
5.6.1 Access Profiles
The menu System Management->Configuration Access->Access Profiles displays a
list of all the access profiles that have been configured. You can delete existing entries with
the icon .
By default, the access profiles *66=35'), @-*0, 6@3A, @-):--4 ,
:D=.A=366 are preconfigured for PABX systems. You can change these using
the icon or reset them to the default settings using the icon .
bintec elmeg GmbH
5 System Management
bintec RS Series 91