Field Description
Prioritize TCP ACK
Packets
Select whether the TCP download is to be optimised in the
event of intensive TCP upload. This function can be specially
applied for asymmetrical bandwidths (ADSL).
The function is enabled with "1.
The function is disabled by default.
LCP Alive Check Select whether the availability of the remote terminal is to be
checked by sending LCP echo requests or replies. This makes
it possible to switch to a backup connection more quickly in the
event of line faults.
The function is enabled with "1.
The function is enabled by default.
Fiels in the IPv4 Advanced Settings menu
Field Description
MTU Enter the maximum packet size (Maximum Transfer Unit, MTU)
in bytes that is allowed for the connection.
With default value 3%, the value is specified by link
control at connection setup.
If you disable 3%, you can enter a value.
Possible values are to .
The default value is .
13.1.2 PPTP
A list of all PPTP interfaces is displayed in the WAN->Internet + Dialup->PPTP menu.
In this menu, you configure an Internet connection that uses the Point Tunnelling Protocol
(PPTP) to set up a connection. This is required in Austria, for example.
13.1.2.1 New
Choose the New button to set up new PPTP interfaces.
13 WAN bintec elmeg GmbH
312 bintec RS Series
To Next Page
Loading...
