Example: (first wireless network on the first wireless module)
The name of the bridge link is made up of the following parts:
(a) Abbreviation for interface type
(b) Number of the wireless module on which the bridge link is configured
(c) Number of the bridge link
Example: 7 (first bridge link on the first wireless module)
The name of the client link is made up of the following parts:
(a) Abbreviation for interface type
(b) Number of the wireless module on which the client link is configured
(c) Number of the client link
Example: (first client link on the first wireless module)
The name of the virtual interface connected to an Ethernet port is made up of the following
parts:
(a) Abbreviation for interface type
(b) Number of the Ethernet port
(c) Number of the interface connected to the Ethernet port
(d) Number of the virtual interface
Example: (first virtual interface based on the first interface on the first Ethernet
port)
5.3.1 Interfaces
You define separately whether each interface is to operate in routing or bridging mode.
If you want to set bridging mode, you can either use existing bridge groups or create a new
bridge group.
The default setting for all existing interfaces is routing mode. When selecting the option
)7 :# + for Mode / Bridge Group, a bridge group, i.e. ", " etc. is
automatically created and the interface is run in bridging mode.
5 System Management bintec elmeg GmbH
70 bintec RS Series
To Next Page
Loading...
