Configuring the WLAN Adapter under Windows XP
After installing the drivers for your WLAN card, Windows XP set up a new connection in the
network environment. Proceed as follows to configure the Wireless LAN connection:
(1) Click on Start -> Settings and double-click on Network Connections -> Wireless
Network Connection.
(2) On the left-hand side, select Change Advanced Settings.
(3) Go to the Wireless networks tab.
(4) Click Add.
Proceed as follows:
(1) Enter a Network Name, e.g. 61 .
(2) Set Network Authentication to 23 4.
(3) Set Data Encryption to 3.
(4) Under Network Key and Confirm Network Key, enter the configured preshared key.
(5) Exit each menu with OK.
Note
Windows XP allows several menus to be modified. Depending on the configuration,
the path to the wireless network connection you want to configure may be different to
that described above.
2.6 Software Update
The range of functions of bintec elmeg devices is continuously being extended. These ex-
tensions are made available to you by bintec elmeg GmbH free of charge. Checking for
new software versions and the installation of updates can be carried out easily with the
GUI. An existing internet connection is needed for an automatic update.
Proceed as follows:
(1) Go to the Maintenance->Software &Configuration menu.
(2) Under Action select .+ ( $7 and, under Source Location
0 $7 $ .+
(3) Confirm with Go.
bintec elmeg GmbH
2 Basic configuration
bintec RS Series 33
To Next Page
Loading...
