BinTec RS353a - Ipv4 Routing Table

10.1.3 IPv4 Routing Table
A list of all IPv4 routes is displayed in the Network->Routes->IPv4 Routing Table menu.
The routes do not all need to be active, but can be activated at any time by relevant data
traffic.
In the ex works state, a predefined entry with the parameters Destination IP Address =
, Netmask = ,Gateway = , Interface =
03)=) , Route Type = )79 A  $%, Protocol = 0%1 is
displayed.
Fig. 95: Network->Routes->IPv4 Routing Table
Fields in the menu IPv4 Routing Table
Field Description
Destination IP Address
Displays the IP address of the destination host or destination
network.
Netmask
Displays the netmask of the destination host or destination net-
work.
Gateway
Displays the gateway IP address. Nothing is displayed here
when routes are received by DHCP.
Interface
Displays the interface used for this route.
Metric
Displays the route's priority.
The lower the value, the higher the priority of the route.
Route Type
Displays the route type.
Extended Route
Displays whether a route has been configured with advanced
parameters.
bintec elmeg GmbH
10 Networking
bintec RS Series 233