Field Value
LED mode Only for WLAN devices
Select the LEDs' lighting behaviour.
Possible values:
• (default value): The LEDS display their default beha-
viour.
• <1#: Only the status LED flashes once per second.
• -$$: All LEDs are disabled.
Show Manufacturer
Names
Here you can determine if the manufacturer part of a MAC ad-
dress is to be "translated". The manufacturer part takes up to
eight characters at the beginning of the MAC address. Instead
of, e.g., 88$8&,88%, :%6=&,88% is dis-
played if this option is enabled.
Fields in the menu Power Settings (for devices with GPS only)
Field Value
Power Off Timeout Enter the time, in seconds, for how long the device is to remain
switched on after switching the motor off.
The default value is seconds.
5.2.2 Passwords
Setting the passwords is another basic system setting.
bintec elmeg GmbH
5 System Management
bintec RS Series 59
To Next Page
Loading...
