BinTec RS353a - Ipv6 Route Configuration

Field Description
according to RFC 3260 is used to signal the priority of IP
packets (indicated in decimal format).
• 56 @?%1 E1: Differentiated Services Code
Point according to RFC 3260 is used to signal the priority of
IP packets (indicated in hexadecimal format).
• *- :( E1: The TOS value is specified in binary
format, e.g. 00111111.
• *- 5%1 E1: The TOS value is specified in decimal
format, e.g. 63.
• *- @?%1 E1: The TOS value is specified in
hexadecimal format, e.g. 3F.
Enter the relevant value for 56 :( E1, 56
5%1 E1, 56 @?%1 E1, *- :(
E1, *- 5%1 E1 and *- @?%1
E1.
Mode Select when the interface defined in Route Parameters->Inter-
face is to be used.
Possible values:
• 51+  7 (default value): The route can be used if
the interface is "up". If the interface is "dormant", then dial and
wait until the interface is "up".
• 3: The route can always be used.
• 51+  %: The route can be used when the
interface is "up". If the interface is "dormant", then select and
use the alternative route (rerouting) until the interface is "up".
• ) 1+: The route can be used when the interface is
"up".
• 317( 1+: The route can be used when the interface
is "up". If the interface is "dormant", then dial and wait until the
interface is "up". In this case, an alternative interface with a
poorer metric is used for routing until the interface is "up".
10.1.2 IPv6 Route Configuration
A list of all configured IPv6 routes is displayed in the Network->Routes->IPv6 Route Con-
figuration menu.
10 Networking bintec elmeg GmbH
230 bintec RS Series