Field Description
Used Prefix / Length Only with Type = %
Enter the prefix to be used. Enter the corresponding length. This
prefix must end with ::.
The default value is .
10.3 NAT
Network Address Translation (NAT) is a function on your device for defined conversion of
source and destination addresses of IP packets. If NAT is activated, IP connections are still
only allowed by default in one direction, outgoing (forward) (= protective function). Excep-
tions to the rule can be configured (in NAT Configuration on page 239).
10.3.1 NAT Interfaces
A list of all NAT interfaces is displayed in the Networking->NAT->NAT Interfaces menu.
Fig. 99: Networking->NAT->NAT Interfaces
For every NAT interface, the )3* %, 0+"%9 %, 1 5( and
* # can be selected.
In addition, $7# displays how many port forwarding rules were configured
for this interface.
Options in the menu NAT Interfaces
Field Description
NAT active Select whether NAT is to be activated for the interface.
The function is disabled by default.
10 Networking bintec elmeg GmbH
238 bintec RS Series
To Next Page
Loading...
