Chapter 3 Access and configuration
This chapter describes all the access and configuration options.
3.1 Access Options
The various access options are presented below. Select the procedure to suit your needs.
There are various ways you can access your device to configure it:
• Via your LAN
• Via the console interface
• Via an ISDN connection if your device supports ISDN)
3.1.1 Access via LAN
Access via one of the Ethernet interfaces of your device allows you to to open the GUI in a
web browser for configuration purposes and to access your device via Telnet or SSH.
Caution
If you carry out the initial configuration with the GUI, this can result in inconsistencies
or malfunctions, as soon as you carry out additional settings using other configuration
options. Therefore, it is recommended that the configuration is continued with the GUI.
If you use SNMP shell commands, continue with this configuration method.
3.1.1.1 HTTP/HTTPS
With a current web browser, you can use the HTML interface to configure your device. For
this, enter the following in your web browser's address field
• +8//
or
• +8//
3.1.1.2 Telnet
Apart from configuration using a web browser, with a Telnet connection you can also ac-
cess the SNMP shell and use other configuration options.
bintec elmeg GmbH
3 Access and configuration
bintec RS Series 35
To Next Page
Loading...
Need help?
General
