Field Description
Prioritize TCP ACK
Packets
Select whether the TCP download is to be optimised in the
event of intensive TCP upload. This function can be specially
applied for asymmetrical bandwidths (ADSL).
The function is enabled with "1.
The function is disabled by default.
PPTP Address Mode Displays the address mode. The value cannot be changed.
Possible values:
• %: The Local PPTP IP Address will be assigned to the
selected Ethernet port.
Local PPTP IP Address Assign the PPTP interface an IP address that is used as the
source address.
The default value is .
Remote PPTP IP Ad-
dress
Enter the IP address of the PPTP partner.
The default value is &.
LCP Alive Check Select whether the availability of the remote terminal is to be
checked by sending LCP echo requests or replies. This makes
it possible to switch to a backup connection more quickly in the
event of line faults.
The function is enabled with "1.
The function is enabled by default.
13.1.3 PPPoA
A list of all PPPoA interfaces is displayed in the WAN->Internet + Dialup->PPPoA menu.
In this menu, you configure a xDSL connection used to set up PPPoA connections. With
PPPoA, the connection is configured so that the PPP data flow is transported directly over
an ATM network (RFC 2364). This is required by some providers. Note your provider's spe-
cifications.
When using the internal DSL modem, a PPPoA interface must be configured with Client
Type = - 5 for this connection in WAN->ATM->Profiles->New.
bintec elmeg GmbH
13 WAN
bintec RS Series 317
To Next Page
Loading...
