The menu Advanced Settings consists of the following fields:
Fields in the Advanced Settings menu.
Field Description
Block after connection
failure for
Enter the wait time in seconds before the device should try
again after an attempt to set up a connection has failed. The de-
fault value is .
Maximum Number of
Dialup Retries
Enter the number of unsuccessful attempts to setup a connec-
tion before the interface is blocked.
Possible values are to .
The default value is .
Authentication Select the authentication protocol for this Internet connection.
Select the authentication specified by your provider.
Possible values:
• 3 (default value): Only run PAP (PPP Password Authentic-
ation Protocol); the password is transferred unencrypted.
• 6@3: Only run CHAP (PPP Challenge Handshake Authentic-
ation Protocol as per RFC 1994); password is transferred en-
crypted.
• 3/6@3: Primarily run CHAP, otherwise PAP.
• ' 6@3: Only run MS-CHAP version 1 (PPP Microsoft
Challenge Handshake Authentication Protocol).
• 3/6@3/' 6@3: Primarily run CHAP, on denial then the
authentication protocol required by the connection partner.
(MSCHAP version 1 or 2 possible.)
• ' 6@3: Run MS-CHAP version 2 only.
• ): Some providers use no authentication. In this case, se-
lect this option.
DNS Negotiation Select whether your device receives IP addresses for Primary
DNS Server and Secondary DNS Server from the connection
partner or sends these to the connection partner.
The function is enabled with "1.
The function is enabled by default.
13 WAN bintec elmeg GmbH
316 bintec RS Series
To Next Page
Loading...
