Field Description
Description Enter a name for uniquely identifying the connection partner.
The first character in this field must not be a number No special
characters or umlauts must be used.
Connection Type Select which layer 1 protocol your device should use.
This setting applies for outgoing connections to the connection
partner and only for incoming connections from the connection
partner if they could be identified on the basis of the calling
party number.
Possible values:
• 5) 9"+: For 64-kbps ISDN data connections.
• 5) 9"+: For 56-kbps ISDN data connections.
User Name Enter your device code (local PPP user name).
Remote User (for Dial-
in only)
Enter the code of the remote terminal (remote PPP user name).
Password Enter the password.
Always on Select whether the interface should always be activated.
The function is enabled with "1.
The function is disabled by default.
Only activate this option if you have Internet access with a flat-
rate charge.
Connection Idle
Timeout
Only if Always on is disabled.
Enter the idle interval in seconds. This determines how many
seconds should pass between sending the last traffic data pack-
et and clearing the connection.
Possible values are to & (seconds). deactivates the
timeout. The default value is .
Fields in the IP Mode and Routes menu.
bintec elmeg GmbH
13 WAN
bintec RS Series 325
To Next Page
Loading...
