Field Description
• 3/6@3: Primarily run CHAP, otherwise PAP.
• ' 6@3: Only run MS-CHAP version 1 (PPP Microsoft
Challenge Handshake Authentication Protocol).
• 3/6@3/' 6@3: Primarily run CHAP, on denial then the
authentication protocol required by the connection partner.
(MSCHAP version 1 or 2 possible.)
• ' 6@3: Run MS-CHAP version 2 only.
• ): Some providers use no authentication. In this case, se-
lect this option.
Encryption Only for Authentication = ' 6@3
If necessary, select the type of encryption that should be used
for data traffic to the connection partner. This is only possible if
STAC or MS-STAC compression is not activated for the con-
nection. If Encryption is set, the remote terminal must also sup-
port it, otherwise a connection cannot be set up.
Possible values:
• ) (default value): MPP encryption is not used.
• "1: MPP encryption V2 with 128 bit is used to RFC
3078.
• 27 %+"1: MPP encryption V2 with 128 bit is
used as compatible with Microsoft and Cisco.
Callback Mode Select the Callback Mode function.
Possible values:
• ) (default value): Your device does not call back.
• 3%: Select one of the following options:
• ) #: Your device calls the connection
partner to request a callback.
• 27 61 ': Your device calls the connection
partner to request a callback via CBCP (Callback Control
Protocol). Needed for Windows clients.
• : Select one of the following options:
• )# 605: Your device calls back im-
mediately when requested to do so by the connection part-
ner.
13 WAN bintec elmeg GmbH
328 bintec RS Series
To Next Page
Loading...
