Field Description
The function is disabled by default.
Local IP Address Only for IP Address Assignment = % or 4 6$#
'
Enter the WAN IP address of your IPSec tunnel. This can be the
same IP address as the address configured on your router as
the LAN IP address.
Metric
Only for IP Address Assignment = % or 4 6$#
' 61 and Default Route = "1
Select the priority of the route.
The lower the value, the higher the priority of the route.
Value range from to . The default value is .
Route Entries Only for IP Address Assignment = % or 4 6$#
' 61
Define routing entries for this connection partner.
• A 3: IP address of the destination host or
LAN.
• )9: Netmask for A 3.
• '%: The lower the value, the higher the priority of the
route (possible values ). The default value is .
Fields in the menu Additional IPv4 Traffic Filter (appears only for IP Version of the
tunneled Networks = IPv4 or IPv4 and IPv6)
Field Description
Additional IPv4 Traffic
Filter
Only for Internet Key Exchange = 4
Use Add to create a new filter.
Fields in the IPv6 Interface Routes menu (appears only for IP Version of the
tunneled Networks = IPv6 or IPv4 and IPv6)
Field Description
Security Policy Select the security settings to be used with the interface..
bintec elmeg GmbH
14 VPN
bintec RS Series 359
To Next Page
Loading...
