Field Description
setting under Public Interface Mode.
Public Interface Mode
Only when an interface is selected for Public Interface.
Specify how strictly the setting is handled.
Possible values:
• <%: Only the selected interface is used, independently
from the priorities in the current routing table.
• $: The priorities in the current routing table will be
used. Only if several equivalent routes are available, the route
via the selected interface will be applied.
Public Source IPv4 Ad-
dress
If you are operating more than one Internet connection in paral-
lel, here you can specify the public IP address that is to be used
as the source address for the peer's data traffic. Select whether
the Public Source IPv4 Address is to be enabled.
The function is enabled with "1.
In the input field, enter the public IP address that is to be used
as the sender address.
The function is disabled by default.
IPv4 Back Route Verify Select whether a check on the back route should be activated
for the interface to the connection partner.
The function is enabled with "1.
The function is disabled by default.
MobIKE
Only for peers with IKEv2.
MobIKE In cases of changing public IP addresses, enables only
these addresses to be updated in the SAs without the SAs
themselves having to be renegotiated.
The function is enabled by default.
Note that MobIKE requires a current IPSec client, e. g. the cur-
rent Windows 7 or Windows 8 client or the latest version of the
bintec elmeg IPSec client.
IPv4 Proxy ARP Select whether your device is to respond to ARP requests from
bintec elmeg GmbH
14 VPN
bintec RS Series 365
To Next Page
Loading...
