Field Description
Enable or disable alive check.
The function is enabled by default.
Block Time Define how long a peer is blocked for tunnel setups after a
phase 1 tunnel setup has failed. This only affects locally initiated
setup attempts.
Possible values are to (seconds); means the
value in the default profile is used and means that the peer is
never blocked.
The default value is &.
NAT Traversal NAT Traversal (NAT-T) also enables IPSec tunnels to be
opened via one or more devices on which network address
translation (NAT) is activated.
Without NAT-T, incompatibilities may arise between IPSec and
NAT (see RFC 3715, section 2). These primarily prevent the
setup of an IPSec tunnel from a host within a LANs and behind
a NAT device to another host or device. NAT-T enables these
kinds of tunnels without conflicts with NAT device, activated
NAT is automatically detected by the IPSec Daemon and NAT-T
is used.
Only for 4 +$1
Possible values:
• "1 (default value): NAT Traversal is enabled.
• 5"1: NAT Traversal is disabled.
• <%: The device always behaves as it would if NAT were in
use.
Only for 4 +$1
The function is enabled with "1.
The function is enabled by default.
CA Certificates Only for Phase-1 (IKE) Parameters
Only for Authentication Method = 53 #, A3
# or A3 %(+
14 VPN bintec elmeg GmbH
378 bintec RS Series
To Next Page
Loading...
