Field Description
at which the phase 2 keys are to be regenerated.
The percentage entered is applied to both the lifetime in
seconds and the lifetime in kBytes.
The default value is %.
The menu Advanced Settings consists of the following fields:
Fields in the Advanced Settings menu.
Field Description
IP Compression Select whether compression is to be activated before data en-
cryption. If data is compressed effectively, this can result in
higher performance and a lower volume of data to be trans-
ferred. In the case of fast lines or data that cannot be com-
pressed, you are advised against using this option as the per-
formance can be significantly affected by the increased effort
during compression.
The function is enabled with "1.
The function is disabled by default.
Alive Check Select whether and how IPSec heartbeats are used.
A bintec elmeg IPSec heartbeat is implemented to determine
whether or not a Security Association (SA) is still valid. This
function sends and receives signals every 5 seconds, depend-
ing on the configuration. If these signals are not received after
20 seconds, the SA is discarded as invalid.
Possible values:
• 3% (default value): Automatic detection of whether
the remote terminal is a bintec elmeg device. If it is, @
" M?+%! (for a remote terminal with bintec
elmeg) or % (for a remote terminal without bintec el-
meg) is set.
• %: Your device sends and expects no heartbeat. Set
this option if you use devices from other manufacturers.
• @" ?+% 1(!: Your device expects a
heartbeat from the peer but does not send one itself.
• @" 1(!: Your device expects no heart-
bintec elmeg GmbH
14 VPN
bintec RS Series 383
To Next Page
Loading...
