Field Description
The available values are to &.
UDP Destination Port Enter the destination port number to be used for all calls based
on this profile. The remote LNS that receives the call must mon-
itor this port on L2TP connections.
Possible values are to &.
The default value is , (RFC 2661).
The menu Advanced Settings consists of the following fields:
Fields in the Advanced Settings menu.
Field Description
Local IP Address Enter the IP address to be used as the source address for all
L2TP connections based on this profile.
If this field is left empty, your device uses the IP address of the
interface used to reach the remote IP Address by the L2TP tun-
nel.
Hello Intervall Enter the interval (in seconds) between the sending of two L2TP
HELLO messages. These messages are used to keep the tun-
nel open.
The available values are to , the default value is &. The
value means that no L2TP HELLO messages are sent.
Minimum Time
between Retries
Enter the minimum time (in seconds) that your device waits be-
fore resending a L2TP control packet for which it received no re-
sponse.
The wait time is dynamically extended until it reaches the Max-
imum Time between Retries. The available values are to
, the default value is .
Maximum Time
between Retries
Enter the maximum time (in seconds) that your device waits be-
fore resending a L2TP control packet for which it received no re-
sponse.
The available values are to , the default value is .
Maximum Retries Enter the maximum number of times your device is to try to re-
14 VPN bintec elmeg GmbH
394 bintec RS Series
To Next Page
Loading...
