Field Description
If a port number range is specified, in the second field enter the
last port of the port range. By default the field does not contain
an entry. If a value is displayed, this means that the previously
specified port number is verified. If a port range is to be
checked, enter the upper limit here.
Possible values are to &.
Source Port Range Only for Protocol = *6, .5/*6 or .5
In the first field, enter the source port to be checked, if applic-
able.
If a port number range is specified, in the second field enter the
last port of the port range. By default the field does not contain
an entry. If a value is displayed, this means that the previously
specified port number is verified. If a port range is to be
checked, enter the upper limit here.
Possible values are to &.
Type
Only for Protocol = 6'
The Type field shows the class of ICMP messages, the Code
field specifies the type of message in greater detail.
Possible values:
• 3( (default value)
• % A+1(
• 5 %"1
• % K%
• A%
• %
• * ?%
• "1
• *+
• *+ A+1(
• $ A;
• $ A+1(
15 Firewall bintec elmeg GmbH
430 bintec RS Series
To Next Page
Loading...
