5 The “Confirm Operation” screen will open. Enter the confirmation number, then click OK.
6 The process is complete once you close the confirmation window that appears.
Enabling the iSNS Protocol
By enabling the iSNS protocol on the TeraStation, you can register an iSCSI target (volume) to an iSNS server and use
it to manage the registered targets. To enable the iSNS protocol, follow the procedure below.
1 From Settings, click Storage.
2 Click the settings icon ( ) to the right of “iSCSI”.
3 Click the Internet Storage Name Service (iSNS) tab.
4 Click Edit.
93
Chapter 4 RAID Modes and Drive Management
To Next Page
Loading...
