4
Click [Edit] in [SNTP Settings].
5
Select the [Use SNTP] check box and specify the required settings.
[Use SNTP]
Select the check box to use SNTP for synchronization. If you do not want to use SNTP, clear the check box.
[NTP Server Name]
Enter the IP address of the NTP or the SNTP server. If DNS is available on the network, you can enter "<host
name>.<domain name>" (or FQDN) of up to 255 alphanumeric characters instead (example:
ntp.example.com).
[Polling Interval]
Specify the interval between one synchronization and the next. Specify an interval from 1 to 48 hours.
6
Click [OK].
7
Perform a hard reset.
● Click [Device Control], select [Hard Reset], and then click [Execute].
Network
230
To Next Page
Loading...
