➠ The settings are enabled after the hard reset is performed.
Testing communication with the NTP/SNTP server
● You can view communication status with the registered server by clicking [Settings/Registration]
[Network] [TCP/IP Settings] and then clicking [Check NTP Server Connection] in [SNTP Settings] that
appears. If a proper connection has been established, the result is displayed as shown below. Note that this
operation does not adjust the system clock.
Selecting settings from the operation panel
● You can also enable or disable the SNTP settings from the setting menu of the operation panel.
SNTP(P. 384)
Network
231
To Next Page
Loading...
