3
Load the paper so that the edge of the paper stack is aligned against the paper guide
on the rear side of the paper drawer.
● Insert the paper with the print side face down.
● Fan the paper stack well, and tap it on a at surface to align the edges.
Do not exceed the load limit line when loading paper
● Make sure that the paper stack does not exceed the load limit line (
). Loading too much paper can
cause paper jams.
● When loading paper with a logo, see Loading Preprinted Paper(P. 55) .
4
Set the paper drawer.
»
Continue to Specifying the Size and Type of the Paper in the Paper Drawer(P. 60)
When changing the paper size or type
● If the paper size setting is other than <Auto> or if you load a different type of paper into the machine,
make sure to change the settings. If you do not change the paper size or type setting, the machine cannot
print properly.
Printing on the Back Side of Printed Paper (Manual 2-Sided Printing)
Basic Operations
40
To Next Page
Loading...
