Case IH DCX101 - Disassembly: Flotation Spring Wrench

SECTION 39 - FRAMES - CHAPTER 1
39-5
DISASSEMBLY: FLOTATION SPRING
WRENCH
Separating the spring nuts from the springs requires
a special tool for holding the spring. Use the
specifications provided to manufacture the proper
tool for your machine using common metal pipe
stock.
19992639
9
Parts List: Flotation Spring Wrench
Qty. Part
1 Metal pipe, minimum 4 inches long with inside
diameter of 3 inches
2 Metal pipe or bar stock, 40″ x1-1/8″
21/2″ square metal key
Local Manufacture:
1. Weld a metal key on the inside of one end of each
4 inch length of pipe.
2. Weld a 40 inch length of pipe or bar stock onto
each 4 inch pipe as shown to form a handle.