SECTION 31 - IMPLEMENT POWER TAKE-OFF (PTO) - CHAPTER 2
31-7
Slip Clutch - Run In
1. If applicable: Loosen the six cap screws, 1,
(three shown), 1/2 turn at a time until all are just
loose. Tighten the cap screws 1/2 turn.
2. Attach a tractor to the disc mower-conditioner as
outlined in the “General Information” section of
this manual, if not already connected.
3. Operate the tractor at 1/3 throttle, and engage
the tractor PTO for several seconds, or until the
slip clutch visibly smokes. Disengage the tractor
PTO. Turn the tractor off. If the clutch does not
slip, disassemble the clutch and check for proper
assembly.
1
50012123
13
4. After slipping the clutch, tighten the six cap
screws, 1, (three shown), 1/2 turn at a time until
the compression plate contacts the clutch
housing.
IMPORTANT: The slip clutch is set at 1356 N
⋅
m
(1000 ft-lb) (static) of breakaway torque. Do not
attempt to alter the setting or damage to the machine
could result.
50012123
1
14
To Next Page
Loading...
