SECTION 31 - IMPLEMENT POWER TAKE-OFF (PTO) - CHAPTER 1
31-12
4. Slide the shield off of the drive shaft.
86065241
1
2
27
5. Remove the cone, 1, by sliding it off of the shaft,
2, as shown above. Spread apart the support
rings, 3, and remove from the grooves.
86065242
3
28
1000 RPM Assembly
1. At the rear yoke, grease the groove, 1. Place
support ring, 2, around the groove so that the
grease fitting, 3, faces the front yoke.
86065247
86065245
1
3
2
29
To Next Page
Loading...
