SECTION 58 - ATTACHMENTS / HEADERS - CHAPTER 1
58-22
CUTTER BAR DISASSEMBLY
1. If not already removed, remove the disc, rock
guard and skid shoe from the module to be
removed in order to gain access to the tie bolts.
Loosen the tie bolts by installing the special
holding tools, 1, on one end of each tie bolt. Use
special wrench attachment, 2, with a 3/4″
breaker bar to loosen the front and rear nuts
alternately a flat at a time until nuts can be turned
freely by hand.
IMPORTANT: Do not loosen one nut completely as
this will cause cutter bar to bow and may cause
failure of the opposite tie bolt.
NOTE: If the tie bolts were not previously loosened
with the cutter bar on the machine, it will be
necessary to secure the cutter bar in some manner
prior to attempting to loosen the tie bolts.
1
2
50
2. Slide the cutter bar apart far enough to allow
removal of the disc module, 1.
A3997-10
1
51
To Next Page
Loading...
