Case IH DCX101 - Cutter Bar Driveshaft; Roll Drive; Upper Roll Pivot Arms; Wheel Arms and Header Lift Arms

SECTION 00 - GENERAL INFORMATION - CHAPTER 3
00-8
ROLL DRIVE
Fittings, 1, 2, and 3, top roll drive shaft (4 -- 6 pumps)
Fitting, 4, belt tightener pivot (4 -- 6 pumps)
NOTE: Figure shows conditioner drive belt and idler
removed for clarity.
A3659-36
4
1
2
3
13
CUTTER BAR DRIVESHAFT
Fittings, 1, (3 fittings) (4 -- 6 pumps every 8 hours)
WARNING
Disengage the PTO, turn off the tractor engine
and remove the key. Wait for all movement to
stop before leaving operator’s position. Never
adjust, lubricate, clean or unplug machine with
the engine running. Failure to comply could
result in death or serious injury.
20011832
1
14
UPPER ROLL PIVOT ARMS
Fitting, 1, on each upper roll arm (4 -- 6 pumps)
WHEEL ARMS AND HEADER LIFT ARMS
Fitting, 2, on each header lift arm and 3, on each
wheel arm (4 -- 6 pumps)
WARNING
Disengage the PTO, turn off the tractor engine
and remove the key. Wait for all movement to
stop before leaving operator’s position. Never
adjust, lubricate, clean or unplug machine with
the engine running. Failure to comply could
result in death or serious injury.
20004618
2
3
1
15