Case IH DCX101 - Chapter 3 - Lubrication

SECTION 00 - GENERAL INFORMATION - CHAPTER 3
00-1
SECTION 00 -- GENERAL INFORMATION
Chapter 3 -- Lubrication
CONTENTS
Section Description Page
Lubrication 2....................................................................
Recommended Lubricants 2...................................................
Lubrication Schedule 3...........................................................
Grease Fittings 3............................................................
Gearboxes 3.................................................................
PTO Slide Collar 4............................................................
Weasler Primary PTO 4.......................................................
Every 50 Hours 5.............................................................
Bondioli Primary PTO 5.......................................................
Secondary PTO 6............................................................
Front CV Joint 6..........................................................
Telescoping Section 7.....................................................
Rear CV Joint and Slip Clutch Assembly 7....................................
Roll Drive 8..................................................................
Cutter Bar Drive Shaft 8.......................................................
Upper Roll Pivot Arms 8.......................................................
Wheel Arms and Header Lift Arms 8............................................
Tongue Pivot Pin 9............................................................
Wheel Bearings 9............................................................
Cutter Bar Mounting Bolts 9....................................................
After First 50 Hours 10.......................................................
Step-up Gearbox 10.........................................................
Every 100 Hours 11...........................................................
Roll Pressure Crank 11........................................................
Bevel Gearbox 11............................................................
Every 200 Hours 13..........................................................
Roll Drive Gearbox 13........................................................
Every 200 Hours 13..........................................................
Cutter Bar Modules 13.......................................................
Every 400 Hours 14..........................................................
Wheel Bearings 14..........................................................