SECTION 00 - GENERAL INFORMATION - CHAPTER 1
00-7
HARDWARE TORQUE VALUES
Check the tightness of hardware periodically.
Use the following charts to determine the correct
torque when checking, adjusting or replacing
hardware on the tractor.
IMPORTANT: DO NOT use the values listed in the
charts if a different torque value or tightening
procedure is specified in this manual for a specific
application. Torque values listed are for general use
only.
Install a lock washer on all bolts unless a locknut or
jam nut is specified.
Install a flat washer at all slotted holes unless a
carriage bolt or flanged head bolt is specified.
Make sure fastener threads are clean and not
damaged.
NOTE: A torque wrench is necessary to properly
torque hardware.
To Next Page
Loading...
