SECTION 00 - GENERAL INFORMATION - CHAPTER 1
00-24
SPECIFICATIONS
Overall Width
Transport position 3429 mm (11 ft 3 in)...............................................
Field position 4877 mm (16 ft 0 in)....................................................
Overall Length
Transport position 5131 mm (16 ft 10 in)...............................................
Field position 4750 mm (15 ft 7 in)....................................................
Height
Transport position 1600 mm (5 ft 3 in)...............................................
Cutting position 1346 mm (4 ft 5 in)..................................................
Ground Clearance (transport) 457 mm (18 in)........................................
Wheel Tread Width 2643 mm (8 ft 8 in).................................................
Weight 1864 kg (4100 lb)...........................................................
Driveline
Tractor Requirement 60 kw (80 HP) Minimum.............................................
with two remote circuits
with minimum of 1043 kPa
(1500 PSI) relief pressure
Input Speed 540 or 1000 RPM.....................................................
Drive Protection Main driveline - slip clutch.................................................
with overrunning clutch,
conditioner roll drive - V-belt with
spring loaded idler
Header
Cutting Width 3160 mm (10 ft 4 in)...................................................
Flotation Vertical and radial........................................................
Windrow Width 914 -- 2134 mm (36 -- 84 in)..................................................
Header Lift Hydraulic (master-slave system)......................................................
Cutter Bar
Type Modular..........................................................
No.ofDiscs 8....................................................
Knives Per Discs 2................................................
Disc Cutting Diameter 500 mm (19.7 in)............................................
Disc Drive Bevel gears in sealed modules......................................................
Disc Speed 3000 RPM.....................................................
Cutting Height 32 -- 76 mm (1.25 -- 3 in)...................................................
Cutter Bar Angle --2 degree to --10 degrees.................................................
Conditioner
Type Intermeshing rolls..........................................................
Drive 4HB v-belt and spur gears..........................................................
To Next Page
Loading...
