SECTION 00 - GENERAL INFORMATION - CHAPTER 1
00-5
14. The header should be resting on the ground
or suspended in the transport position by the
header lift locks during lubrication or
maintenance.
15. Replace damaged knives, knife hardware or
discs immediately to prevent an accident.
16. The bottom leading edge of worn discs can
become very sharp; wear gloves to prevent
injury.
17. Replace cracked or severely deformed
knives immediately to prevent an accident.
18. The tractor end of the primary PTO shaft has
a CV joint which is heavy. Be careful when
handing it; dropping it could cause personal
injury to yourself and damage the CV joint.
19. Before disconnecting the lift cylinder hose,
be sure the header is resting on the ground or
on the header lift locks.
20. Always replace or close all shields after
making repairs, adjustments, or after lubrica-
ting. Shields are for your protection. Keep
them in place!
21. Do not weld on wheels. Welding on wheels
may cause high stress and a wheel failure.
22. Do not weld on wheels with a mounted tire.
Welding on wheels with a mounted tire may
cause the tire to burst, causing serious injury
or death.
To Next Page
Loading...
