SECTION 00 - GENERAL INFORMATION - CHAPTER 2
00-9
For 10 degree header tilt, store pin in the lower plate
holes, 1, as shown. This position does not restrict the
tilt cylinder stroke, and allows the header to tilt
forward to the lowest cutting height.
If a stone or obstacle is seen when the machine is
being operated in the 5 degree or 10 degree position
the header angle can be retracted to 2 degrees
without lifting the header. Just move the tractor lever
to the raise position long enough to retract the tilt
cylinder. After the obstacle is passed extend the
cylinder by moving the tractor lever to the lowering
position.
WARNING
If stones or other foreign objects enter the cutter
bar, they can be deflected toward the operator or
bystanders, resulting in physical injury. Adjust
the cutter bar angle and, or raise header to clear
stones and foreign objects.
19982133
1
15
To Next Page
Loading...
