Cisco D9854 - Page 259

4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide 6-11
Transport
Processing
Set PTI lockup Cause: Possible
software issue
Remedy: Clear
alarms, reset unit,
and notify customer
service if problem
persists
Programmable
transport input
module stopped
processing any
data packet.
Minor
Clear PTI running
Temperature
Alarm
Set Temperature over
Alarm threshold
Cause: Room
temperature too high,
or air flow is blocked.
Remedy: Check
openings on front
and rear panels for
blockage. Lower
room temperature or
improve air flow to
device.
Temperature is
above safe
operating range.
Major
Clear Temperature normal
Fan Set Fan Failure Alarm Cause: Hardware
issue.
Remedy: Unit should
be returned to
customer service as
soon as possible.
Fan failure Major
Fan RPM Alarm Fan RPM out of
normal
operating range.
Clear Clear Fans Alarm
FPGA
Temperature
Alarm
Set Temperature over
Alarm threshold
Cause: Room
temperature too high,
or air flow is blocked.
Remedy: Check
openings on front
and rear panels for
blockage. Lower
room temperature or
improve air flow to
device.
FPGA
temperature is
above safe
operating range.
Major
Clear Temperature normal
Alarm Message
Type
Message Cause/Remedy Description Severity