Cisco D9854 User Manual

6-12 Model D9854 Advanced Program Receiver Installation and Operation Guide 4021470 Rev D
ASI Out Status Set ASI Overflow.
Output Muted.
Reduce content.
Cause: Uplink
settings may have
changed since setup
of the unit. Variable
Bit Rate/Statmuxed
streams may be in
use.
Remedy:
Increase the output
rate, drop
unreferenced content
in DPM Options,
and/or drop
programs not needed
for downstream
devices. Contact
your (uplink) service
provider to verify the
expected bit rate
settings.
Current
transport rate
exceeds
configured rate
for ASI output.
Output has been
muted to protect
downstream
devices.
Minor
Clear ASI Output Restored
MPoIP Status Set MPEGoIP Overflow.
Output Muted.
Reduce content.
Cause: Uplink
settings may have
changed since setup
of the unit. Variable
Bit Rate/Statmuxed
streams may be in
use.
Remedy:
Increase the output
rate, drop
unreferenced content
in DPM Options,
and/or drop
programs not needed
for downstream
devices. Contact
your (uplink) service
provider to verify the
expected bit rate
settings.
Current
transport rate
exceeds
configured rate
for MPEG over
IP output.
Output has been
muted to protect
downstream
devices.
Minor
Clear MPEGoIP Output
Restored
Alarm Message
Type
Message Cause/Remedy Description Severity

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C